Inhoudsopgave
Advertenties
To collecting the milk after expression:
6. Take out the pump from your nursing bra.
7. Press the button in the middle of the device in order to release the milk bottle.
8. Pour the breast milk into a feeding bottle in the indicated direction as shown in figure V-8.
Storing breast milk:
Warning! Always refrigerate or freeze expressed milk immediately. Store only fresh milk. Store only breast milk collected with a cleaned and sanitized pump to ensure
hygiene. Always store breast milk in sanitized containers or bottles fitted with a sanitized screw ring and sealing disc or in pre-sterilized milk storage bags. Do NOT fill the
containers, bottles or the milk bags completely. Leave some space as milk volume increases during freezing.
• Always clearly label the date and time of expression on the containers, bottles or the milk bags.
• Always use older breast milk first.
• In order to keep the nutritional content of the breast milk, thaw in a refrigerator compartment or under running tap water without opening the container, bottle or bag.
Stored milk can be thawed overnight in a refrigerator, then gradually heated in a warmer or hot water.
• Shake the thawed milk to mix fat particles and the remaining milk ingredients. Thawed milk is usable for 24 hours if it is stored in the refrigerator.
• Never refreeze thawed milk.
• Never combine freshly expressed and thawed milk.
• Never heat milk by boiling or using the microwave.
• Always check food temperature before feeding.
• Discard any milk that is left over.
Freshly expressed breast milk storage guidelines (for healthy term babies)
• Room temperature up to 25°C, up to 4 hours.
• Cooler with frozen ice packs -15°C to 4°C, up to 24 hours.
• Refrigerator 4°C, up to 3 days.
• Freezer -18°C to -20°C, up to 6 months.
Thawed breast milk storage guidelines (for healthy term babies)
• Room temperature up to 25°C, up to 2 hours.
• Cooler with frozen ice packs -15°C to 4°C, up to 2 hours.
• Refrigerator 4°C, up to 24 hours.
• Freezer NEVER REFREEZE thawed breast milk.
Breast milk left from a feeding:
Discard any milk that is leftover.
Baby feeding:
• Inspect the feeding nipple before each use and pull the feeding nipple in all directions. Throw away at the first signs of damage or weakness.
• Never dip the nipple in sweet substances or medication, your child may get tooth decay.
• Do not microwave. Do not heat the product in traditional ovens or on hot plates or open flames.
For your child's safety and health WARNING!
Continuous and prolonged sucking of fluids will cause tooth decay.
Always check food temperature before feeding.
Throw away at the first signs of damage or weakness.
Keep components not in use out of the reach of children.
Never attach to cords, ribbons, laces or loose parts of clothing. The child can be strangled.
Always use this product with adult supervision.
Never use feeding teats as a soother.
Tooth decay in young children can occur even when non-sweetened fluids are used. This can occur if the baby is allowed to use the bottle for long periods through the day and
particularly through the night, when saliva flow is reduced or if it is used as a soother.
Accidents have occurred when babies have been left alone with drinking equipment due to the baby falling or if the product has disassembled.
EN
Troubleshooting:
Problem: I experience pain when I use the breast pump.
Solution 1: One of the reasons can be the too high vacuum level. Maybe you do not need the full vacuum power of the breast pump.
At first use the stimulation or massage mode. If you still feel pain, stop using the breast pump and consult your breastfeeding advisor. If the pump
does not come away easily from the breast, it may be necessary to break the vacuum by placing a finger between the breast and the silicone shield.
Solution 2: Use a warm towel to apply warm compress on breast and do massage with a little bit downward gesture for about 5 minutes, then try the pumping again. If you
still feel pain, stop using the breast pump and consult your breastfeeding advisor.
Problem: The breast pump does not work.
Solution: Please, first check if you have assembled the breast pump correctly. To prevent interference keep other electric equipment, like mobile phone or laptop, away from
the breast pump while expressing. Check the battery and if needed charge it. If it still can not work, please contact to the aftersales service.
Problem: I do not feel any suction.
Solution: Check whether all breast pump connections are secure. Disassemble and assemble the pump (figure III; figure IV). Assembling your breast pump, make sure all
pieces are clean and not damaged. While pumping, make sure the breast shield is completely sealed around your breast.
Problem: There is milk overflow.
Solution: Turn off the breast pump. Disassemble the breast pump. Use a damp (not wet) cloth to wipe the breast pump. Clean other components according to clean and
sanitize section. When all components are dry, reassemble (figure IV).
Usage and storage conditions:
Keep the breast pump out of direct sunlight as prolonged exposure may cause discoloration. Store the breast pump and its accessories in a safe, clean and dry place without
direct sunlight and away from heat sources. If the appliance has been stored in a hot or cold environment, place it in the usage environment to let it reach a temperature
within the usage conditions (10°C - 30°C) before you use it.
Technical specifications:
Model: Wearable breast pump Winnie 31304010038
Pumping power: 165-240/mmHg; Stimulation power: 90-165/mmHg
Noise limited: <50db;
Fixed time: 30 minutes; Usage time: 2.5 hours;
Lithium battery: 3.7V, 1500mAh Li-ion; Charging time: 3 hours;
Protection against electric shock: Class II;
Power in: 5V 1A, 110-240V 50-60Hz;
Environmental conditions for operation: temperature 5-40°C, relative humidity 10-90%, atmospheric pressure 50kPa~106kPa;
Environmental conditions for storage: temperature 5-40°C, relative humidity 10-90%, atmospheric pressure 50kPa~106kPa;
Adapter input: 110-240V 50~60Hz, output: 5V 1A 3.0W;
Capacity 140ml;
Size: 10.5x5x12.7cm, weight 234g.
Complies with EN 55014, Regulation (EU) 2020/1245, RoHS Directive, EN 61000, EN 55032. Produced for Kika Group Ltd. Made in China.
EN
Advertenties
Inhoudsopgave
