Advertenties
Setting the orbital action
1.Determine the correct orbital-action setting for the task to be performed with the applicable saw
blade.
2.Set the orbital-action adjusting lever to one of the four settings
Adjusting the stroke rate
Determine the correct setting for the task to be performed with the applicable saw blade.
▶
Set the stroke rate regulator thumbwheel to a setting between 1 (low) and 6 (high).
Setting the cutting angle
1.Remove the dust removal adapter.
2.Pivot the clamping lever 90° back (toward the rear of the tool).
3.Set the desired cutting angle (0°, 15°, 30° or 45°).
4.Pivot the clamping lever 90° forward (toward the front of the tool).
▶
The base plate is clamped securely.
5.Fit the dust removal adapter.
Fitting the anti-splinter insert
The anti-splinter insert can be used only with the saw blades for which it is designed.
1.Disconnect the supply cord plug from the power outlet.
2.Press the anti-splinter insert into the base plate from below.
Operation
WARNING
Damaged power cords are a safety hazard! If the supply cord or extension cord is damaged while
work is in progress, immediately disconnect the device and the cord from the electricity supply. Do
not touch the damaged part of the cord.
▶
Regularly check all supply cords. Replace defective extension cords. Have damaged power cords
replaced by a qualified specialist.
Use of a ground fault circuit interrupter (residual current device, RCD) with a maximum tripping
current of 30 mA is recommended.
Dust removal system
The dust extractor reduces dust emissions, increases working safety by providing better visibility
of the cutting line and reduces exposure to dust and wood chips at the workplace.
1.Fit the guard.
18
2.Connect the dust removal adapter and the extractor when you intend working for a long period on
wood or other materials, because high concentrations of dust can be produced in these operations.
10
Switching on
1.Press the on/off switch.
2.To lock the switch, subsequently press the lockbutton.
3.To release the lockbutton, press the on/off switch again.
Plunge cutting
1.Set the orbital-action adjusting lever to position 0.
2.Bring the front edge of the base plate into contact with the workpiece.
3.Hold the product securely and press the on/off switch.
4.Press the product firmly against the workpiece and begin the plunge cut by slowly reducing the
angle of attack.
19
6
7
8
20
18
9
16.
2143763
*2143763*
Advertenties
