Advertenties
Anti-splinter insert
The product can be equipped with an anti-splinter insert.
The anti-splinter insert helps prevent splintering on the surface of wood materials when cutting.
Items supplied
Orbital-action jig saw with saw blade, guard, dust removal adapter, anti-splinter insert, operating
instructions, hex key.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
Technical data
Orbital-action jig saw
When powered by a generator or transformer, the generator or transformer's power output
must be at least twice the rated input power shown on the rating plate of the power tool. The
operating voltage of the transformer or generator must always be within +5% and -15% of the
rated voltage of the power tool.
The information given applies to a rated voltage of 230 V. The data may vary in the event of
deviations from the rated voltage and for country-specific versions. Please refer to the power
tool's type identification plate for details of its voltage, frequency, current and input power
ratings.
Product generation
Rated power input
Weight in accordance with EPTA procedure 01
Stroke rate under no load
Stroke length
Maximum cutting performance in wood
Maximum cutting performance in aluminum
Maximum cutting performance in unalloyed steel
Cutting angle (left/right)
Dust removal adapter outside diameter
Noise information and vibration values
The sound pressure and vibration values given in these instructions were measured in accordance
with a standardized test and can be used to compare one power tool with another. They can also be
used for a preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used
for different applications, with different accessory tools, or is poorly maintained, the data can vary.
This can significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is
switched off, or when it is running but not actually being used for a job. This can significantly reduce
exposure over the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration,
for example: maintaining the power tool and accessory tools, keeping the hands warm, organization
of work patterns.
Detailed information on the versions of the EN 62841 standards applied here is to be found in
the reproduction of the declaration of conformity
17
SJD 6
01
850 W
2.4 kg
80 /min ... 3,000 /min
28 mm
150 mm
25 mm
10 mm
0°, 15°, 30°, 45°
27.5 mm
236.
2143763
*2143763*
Advertenties
