Inhoudsopgave
Advertenties
All manuals and user guides at all-guides.com
467817_Laubblaeser_Benzin.book Seite 34 Montag, 30. Mai 2016 4:19 16
GB
– Push the speed switch (6) into position F.
– Pull the pull-starter (4) vigorously several times.
– Push the choke lever (1) into position B.
– Pull the pull-starter (4) vigorously several more
times until the motor starts.
– Let the motor run for five to ten seconds.
– Push the choke lever (1) into position C.
Starting the product (warm)
– Push the on/off switch (5) into position "I".
– Push the speed switch (6) into position F.
– Push the choke lever (1) into position B.
– Pull the pull-starter (4) vigorously several times
until the motor starts.
Switching off the product
Figure 12 – Page 5
– Push the speed switch (6) into position E.
– Let the motor idle for a few seconds.
– Push the on/off switch (5) into position "0".
Cleaning and maintenance
Cleaning and maintenance at a glance
Before each use
What
How
Check cable of the
Visual inspection.
pull-starter for
damage.
Every 10 hours of operation
What
How
Clean the air filter.
Cleaning the air
filter – Page 34.
Every 50 hours of operation
What
How
Cleaning/
Check and clean spark
plug.
replacing the spark
plug – Page 34.
Cleaning the product
Danger of fire! Switch off the product
completely for cleaning and allow it to
cool down for a few minutes. Hot
motor parts can cause severe burns.
– Brush off coarse dirt.
34
– Wipe down the product with a slightly damp
cloth.
– Empty the collecting sack regularly and clean if
necessary.
Maintenance
Product damage! The product must
never be operated without the air filter,
since this can cause damage to the
motor.
Cleaning the air filter
Figure 13 – Page 5
– Push the choke lever (1) into position B.
– Loosen the screws (19) on the cover (20).
– Remove the cover (20).
Figure 14 – Page 5
– Remove the air filter (21).
– Wash out the air filter thoroughly and let it dry.
• Use water with cleanser for this purpose.
– Apply a thin coat of oil to the air filter (21).
– Insert the air filter into the cover (20).
– Replace the cover (20) and fasten it with
screws (19).
Cleaning/replacing the spark plug
Risk of burns! Before beginning work,
switch the product's motor off and
allow it to cool down.
Product damage! To clean the spark
plug, use only wire brushes with brass
bristles. Bristles of any other material
will damage the electrode! Fit spark
plug spark only when motor is cold.
Use specified spark plug (see
Technical data – Page 36).
Changing the spark plug
Figure 15 – Page 5
– Pull off the spark plug connector (22).
– Unscrew the spark plug (23) counter-clockwise.
– Check the electrode for discolouration.
• Standard colour: light brown.
Figure 16 – Page 5
– Check the electrode distance.
• Correct distance: 0,5 mm.
– Screw in the cleaned or new spark plug clock-
wise by hand.
Advertenties
Hoofdstukken
Inhoudsopgave
