Inhoudsopgave
Advertenties
Description of the Appliance
The scope of delivery of your appliance is illustrated on
the packaging. Check the contents of the appliance for
completeness when unpacking.
In the event of missing accessories or any transport
damage, please contact your dealer.
Illustrations on Page 2
1
Water connection with integrated sieve
2
Coupling element for water connection
3
Quick coupling for high pressure hose
4
Storage for trigger gun
5
Appliance switch „0/OFF" / „I/ON"
6
Dosage regulator for detergent
7
Storage for trigger gun
8
Transport handle
9
Plug 'n' Clean detergent bottle with locking lid
10 Storage of Plug 'n' Clean detergent bottle with de-
tergent connection
11 Storage for high pressure hose
12 Storage for spray lance
13 Storage hook for mains connection cable
14 Mains cable with mains plug
15 Bearing wheel
16 Trigger gun
17 Lock trigger gun
18 Button for detaching the high-pressure hose from
the trigger gun
19 High pressure hose
20 Spray lance with Dirtblaster
For strong contaminations.
21 Spray lance with pressure regulation (Vario Power)
Carrying out the most common cleaning tasks.
The working pressure can be continuously in-
creased from "SOFT" to "HARD". To adjust the
working pressure, release the trigger gun lever and
turn the spray lance to the desired position.
Suitable for use with detergents.
** Additionally required
22 Fabric-reinforced water hose with commercially
available coupling.
– Minimum diameter, 1/2 inches (13 mm).
– Minimum length 7.5 m.
Illustrations on fold-out pages!
Mount loose parts delivered with appliance prior to start-
up.
Install the storage for trigger gun
Illustration
Place the bottom holder into the recesses and push
forward until it audibly locks in.
Illustration
Insert the top holder and push down all the way.
12
Assembly
Install the storage hook for the mains
Illustration
Press in the storage hook and lock it into the top po-
sition.
Install the dosage regulator for detergent
You will need the 2 included screws as well as a Phillips
screwdriver PH 2.
Illustration
Insert both detergent hoses onto the hose fittings.
Install the dosage regulator and connect using 2
screws.
Note: During installation you must make sure that
the tongues of the dosage regulator match up with
the intended recesses in the casing.
Install the transport handle
Illustration
Attach the transport handle, insert the bolts into the
bores and screw them in.
Installing coupling
Illustration
Screw the coupling element to the water connec-
tion on the appliance.
ATTENTION
The highest allowed net impedance at the electrical
connection point (refer to technical data) is not to be ex-
ceeded. In case of confusion regarding the power im-
pedance present on your connection, please contact
your utilities provider.
Park the appliance on an even surface.
Illustration
Push the high pressure hose into the trigger gun
until it locks audibly.
Note: Make sure the connection nipple is aligned
correctly.
Check the secure connection by pulling on the high
pressure hose.
Illustration
Push the high pressure hose into the quick cou-
pling until it locks audibly.
Note: Make sure the connection nipple is aligned
correctly.
Check the secure connection by pulling on the high
pressure hose.
Insert the mains plug into the socket.
– 6
EN
connection cable
Start up
Advertenties
Hoofdstukken
Inhoudsopgave
