Inhoudsopgave
Advertenties
14 electrolux
Installation Instructions
1
Safety instructions
Warning! This must be read!
The laws, ordinances, directives and stand-
ards in force in the country of use are to be
followed (safety regulations, proper recycling
in accordance with the regulations, etc.)
Installation may only be carried out by a qual-
ified electrician.
The minimum distances to other appliances
and units are to be observed.
Anti-shock protection must be provided by
the installation, for example drawers may
only be installed with a protective floor direct-
ly underneath the appliance.
The cut surfaces of the worktop are to be
protected against moisture using a suitable
sealant.
The sealant seals the appliance to the work
top with no gap.
Do not use silicon sealant between the appli-
ance and the work top.
Avoid installing the appliance next to doors
and under windows. Otherwise hot cook-
ware may be knocked off the rings when
doors and windows are opened.
z
Risk of injury from electrical
current.
•
The electrical mains terminal is live.
•
Make electrical mains terminal free of
voltage.
•
Follow connection schematic.
•
Observe electrical safety rules.
•
Ensure anti-shock protection by install-
ing correctly.
•
The appliance must be connected to the
electrical supply by a qualified electri-
cian.
z
Risk of injury from electrical
current.
•
Loose and inappropriate plug and sock-
et connections can make the terminal
overheat.
•
Have the clamping connections correct-
ly installed by a qualified electrician.
•
Use strain relief clamp on cable.
•
In the event of single-phase or two-
phase connection, the appropriate
mains cable of type H05BB-F Tmax
90°C(or higher) or an equivalent type
must be used.
•
If this appliance's mains cable is dam-
aged, it must be replaced by a special
cable (type H05BB-F Tmax 90°C; or
higher) or an equivalent type. The latter
is available from the Customer Care De-
partment.
A device must be provided in the electrical
installation which allows the appliance to be
disconnected from the mains at all poles with
a contact opening width of at least 3 mm.
Suitable isolation devices include line pro-
tecting cut-outs, fuses (screw type fuses are
to be removed from the holder), earth leak-
age trips and contactors.
Advertenties
Hoofdstukken
Inhoudsopgave
