Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2.5 Insert the left chin strap in the left cheek pad slot by pulling it towards the inside of the
helmet; then press the padding onto the snap fastener on the back of the helmet so
that it is hooked in the hooking seat of the frame fixed to the shell (Fig. 11).
WARNING!!!
-
Remove the padding only when cleaning or washing is required.
-
Never use the helmet if the inner comfort padding and the cheek pads have not been
correctly and completely restored.
-
Delicately hand-wash in lukewarm water (max. 30°C) and neutral soap.
-
Rinse off with cold water and dry up at room temperature away from direct sunrays.
-
Never machine-wash the inner comfort padding.
-
The inner polystyrene is an easily deformable material, in fact it is apt to change or get
partially destroyed to help absorb shocks.
-
Use a wet cloth to clean it and let it dry at room temperature away from direct sun-
rays.
-
Do not modify the helmet's internal polystyrene components in any way.
-
Never use tools or equipment of any sort to carry out the steps described above.
•
(Available as an optional accessory)
®
1
PINLOCK
INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjustment
external levers are turned inwards.
1.3 Place the Pinlock
®
the Pinlock
inner visor should be in contact with the inner surface of the visor.
1.4 Insert one side of the Pinlock
tion (Fig. 15).
1.5 Widen the visor and fasten the other side of the Pinlock
(Fig. 16).
1.6 Release the visor.
1.7 Remove the protective film from the Pinlock
cone-sealed profile of the inner visor adheres to the visor.
1.8 Fit the visor in the helmet.
CHECKING AND ADJUSTING THE INNER VISOR STRETCHING
Check the correct system assembly by opening and closing the visor. Check that both
visors are correctly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers simul-
taneously upwards to increase the stretch (Fig. 17). This operation must be carried out gra-
dually. The maximum stretch is achieved when the pin adjustment external levers are tur-
ned outwards.
WARNING!
The presence of dust between the two visors may produce scratches on both surfaces.
Scratched visors and inner visors may cause reduced visibility and must therefore be
replaced.
®
inner visor on the visor. WARNING: The silicone-sealed profile of
®
inner visor on one of the visor pins and hold it in posi-
®
inner visor to the second pin
®
inner visor and check that the entire sili-
16
Advertenties
Inhoudsopgave
