Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTRUCTIONS FOR USE
The N 43 E AIR helmet is equipped with removable chin guard. It can be used with
different configurations (thanks to the accessories supplied in the box) as described
at the end of the paragraph. Using the helmet in its full configuration (chin guard
attached and visor closed) obviously guarantees the best protection when com-
pared to the other configurations.
•
VISOR REMOVAL
1
Lift and remove the safety cover from the latch as shown in Fig. 1 A, rotate the latch
90 degrees towards the front part of the helmet (see Fig. 1 B).
2
Remove the latch from the helmet by pulling it outwards so that the latch inner bayo-
net "A" comes out of its housing in the visor mechanism (see Fig. 2).
3
Follow the same steps on the right side of the helmet.
4
Remove the visor by holding the side end of the visor and bending it outwards so that
the hole "B" of the visor comes unhooked from the visor mechanism and the inner
pawl "C" inside the visor comes out of its housing in the visor mechanism (see Fig. 3).
•
VISOR ASSEMBLY
1
Place the visor on the left visor mechanism paying particular attention to insert the
visor inner pawl "C" next to the lower part of the visor mechanism and the hole "B" on
the special circular projection of the same mechanism (see Fig. 3).
2
Place the left side latch on the visor mechanism and insert the inner bayonet "A" in its
special housing in the side mechanism (see Fig. 2).
3
Turn the latch 90° towards the rear part of the helmet. Carry out this operation by
pushing the latch towards the inside of the helmet. Fix the latch by positioning the
safety cover (see Fig. 1 A). Make sure the cover is firmly attached to the latch.
4
Follow the same steps on the right side of the helmet.
WARNING!!!
-
Make sure that the system is working properly. Open and close the visor making sure
that the mechanism holds it in the different positions.
-
Do not use the helmet if the visor has not been assembled properly.
-
If the visor opening/closing mechanisms are not working properly or if such mecha-
nisms get damaged, please contact a Nolan authorized dealer.
•
CHIN GUARD
1
CHIN GUARD RELEASE
1
Open the visor completely.
2
Pull the right chin guard release lever upwards and at the same time remove the chin
guard from the helmet, by pulling it towards the outside (Fig. 4). Perform the same
operation on the left side of the helmet.
WARNING: every time you wish release the chin guard to use your helmet in the JET
version, insert the right and left CHIN GUARD COVERS in the louvers on the right
and left side frames and push them towards the inside of the helmet until you hear
a fastening click(Fig. 5).
Note: The CHIN GUARD COVERS are all different among them and they are marked
on their back as R (Right) and L (Left).
12
Advertenties
Inhoudsopgave
