Inhoudsopgave
Advertenties
Using the stationary air conditioner
6.5
Extracting condensation (SP950 only)
The condensated water which accumulates due to the way the system works
is automatically extracted at intervals during operation.
You can pump out the condensated water manually when necessary:
➤ Switch off the system.
➤ Press and hold the Operating mode (fig. 2 4, page 3) and – (fig. 2 7,
page 3) buttons simultaneously.
➤ In addition, press the ON/OFF button (fig. 2 1, page 3) briefly.
✓ The firmware version appears in the digital display for 5 seconds.
✓ 000 then appears in the digital display and the system starts the extraction
process for 15 seconds.
You can now let go of the Operating mode (fig. 2 4, page 3) and –
(fig. 2 7, page 3) buttons.
✓ The compressor and the fan do not switch on.
✓ The system switches off automatically.
Note
I
To stop the extraction early press the ON/OFF button until the
pump switches off.
Avoid pumping out the water too many times in succession. The pump can
be damaged if it runs dry (indicated by loud noise during extraction).
6.6
Switching off the stationary air conditioner
You can switch the stationary air conditioner to standby mode or switch it off
completely. Note that the stationary air conditioner consumes power in
standby mode. Therefore, switch off the CA850S stationary air conditioner
whenever possible.
The condensation must be pumped off for the SP950 stationary air
conditioner due to its design. Therefore, switch the SP950 stationary air
conditioner to standbymode after use and any subsequent journey while in
motion. The condensation which accumulated during and after operation is
then drained off.
Switch off the stationary air conditioner completely when it is not in use and
for longer periods (e. g. over the weekend).
32
All manuals and user guides at all-guides.com
EN
Advertenties
Hoofdstukken
Inhoudsopgave
