Advertenties
In order to reboot the camera or restore the factory settings press the reset button. Use an appropriate small
tool.
Camera reboot: Press the reset button once and wait until the camera to restart.
Restore factory settings: Press and hold the reset button for approx. 30 seconds until the status LEDs start
flashing. All settings will be reset to factory default.
4. Initial start-up
Direct connection between camera and PC / laptop
6. Make sure to use a crossover network cable
7. Connect the cable with the Ethernet port of the PC / Laptop and the network camera
8. Connect the power supply to the network camera
9. Configure the IP address of the PC / Laptop to 169.254.0.1
10. Continue with point 5.1 in order to finish the initial installing and build-up a connection to the
camera
Connecting the camera by using a router / switch
8. Make sure to use a pair of patch cables
9. Connect the cable with Ethernet port of the PC / laptop with the router / switch.
10. Connect the cable with the network cable and with the router / switch.
11. Connect the power supply to the network camera
12. If there is a name server (DHCP) available in your network then set the IP address of your PC /
laptop to "automatically receive IP address"
13. If there is no name server (DHCP) available set the IP address of your PC / laptop to 169.254.0.1
14. Continue with point 5.1 in order to finish the initial installing and build-up a connection to the
camera
All manuals and user guides at all-guides.com
Crossed Ethernet cable
Internet
64
English
Advertenties
