9 | cLeaning, storage & DisposaL
clean the waterproof sensor tip after every use. Use a clean cloth
or cotton bud which is moistened with disinfectant, alcohol or warm
water.
To clean the entire device, use a soft cloth slightly moistened with a
mild soapy solution.
Water must never get into the device. If water gets into the device,
remove the battery immediately. Only use the device again when it's
completely dry.
Do not use any harsh cleaning products. never immerse the device
in water. Only the tip is waterproof.
Always store the thermometer with the cap on in order to protect
the sensor. When putting the cap on the device, align
the arrow on the cap with the arrow on the housing.
The device must not be stored or used at too high
or low a temperature or humidity (see technical
specifications), in sunlight, in association with an electrical current or
in dusty locations. Otherwise, inaccuracies can occur.
If prolonged storage is intended, you should remove the battery.
10 | technicaL Data
model
Measurement range
Laboratory measurement precision
clinical repeat precision
Measurement duration
Interval between 2 measurements
Measurement units
Operating conditions
Storage conditions
Dimensions
Weight
Battery
Memory
mt25
34°c – 42,2°c (93,2°F – 108,0°F)
±0,2°c (±0,4°F) in the range from
36°c – 39°c (98°F – 102°F)
±0,3°c (±0,5°F) below 36°c and
above 39°c
0,13 (children), 0,11 (adults)
1 to 2 seconds
At least 5 seconds
°celsius (°c) or °Fahrenheit (°F)
10°c to 40°c (50°F – 104°F) with a
relative humidity of up to 95% (non-
condensing)
-20 °c to 50°c (-0,4°F – 122°F)
with a relative humidity of up to
95% (non-condensing)
38 x 152 x 54 mm
70 g including battery
1 lithium batteyj (type 3v cr-2032)
For 9 measurements
34