Inhoudsopgave
Advertenties
ENGLISH
electrician.
The electrical system to which the
product is connected must be in
compliance
regulations.
An omnipolar switch with a
contact opening distance of 3 mm
or higher should be provided for
installation, enabling complete
disconnection under overvoltage
category III conditions.
Products equipped with three-
phase
wiring
ALWAYS require connection to
380-415V (or only 400V where
required) three-phase lines, or
also 220-240V (or only 230V
where required). Any kind of
modification shall be considered
as product tampering and shall
nullify
the
Products equipped with single-
phase
wiring
ALWAYS require connection to
220-240V (or only 230V where
required) single-phase lines. Any
kind of modification shall be
considered as product tampering
and shall nullify the relative
warranty.
Typical application
Fig. 2÷5;
N.B.
If the appliance is installed at a height of less than 2.5
metres from the floor, it is obligatory to install
protection for moving parts, in the form of a safety
grille. (fig. 3).
Installation
Fig. 6÷20;
Electrical Connections
Single-phase electrical connection (fig.14)
Three-phase electrical connection (fig.15)
with
applicable
(T)
engines
relative
warranty.
(M)
engines
Maintenance / Cleaning
Fig. 21÷24.
Disposal
This product complies with Directive 2012/19/EU on
the management of waste electrical and electronic
equipment (WEEE).
The crossed-out wheeled bin symbol on
the appliance indicates that, at the end of
its useful life, the product must be taken to
a specialised company for transport and
treatment. This company will take care of
the disposal of the various materials
making
up
the
product
subsequent proper recycling.
Alternatively, the manufacturer of the appliance is
obliged to take back the product to be disposed of in
exchange for the purchase of an equivalent appliance.
and
their
9
Advertenties
Inhoudsopgave
