Inhoudsopgave
Advertenties
12
POSSIBLE CORRECTIVE MEASURES
Some problems with macerator functionality have
minor causes which you can rectify yourself.
Please refer to the table below in order to diagnose
and resolve your problems.
THE UNIT MUST ONLY BE OPENED BY AN APPROVED
SERVICE ENGINEER
THE MACERATOR SHOULD ALWAYS BE
DISCONNECTED FROM THE POWER SUPPLY
PROBLEM
PROBABLE CAUSE
• The unit has been
• The unit stops
abnormally
running for too long
(thermal cut-out)
• Defective control
system
• The connected
• The unit starts itself up
intermittently
sanitary appliances
are leaking
• The non-return valve
is leaking
• The vent on the cover
• The motor is juddering
is clogged up
and the water in the
bowl is going down
very slowly
• The height or length of
• The motor is operating
drainage pipework is over
normally but no longer
the specification or there
stops or runs for a long
are too many elbows
time
(reducing flow)
• The pump chamber is
blocked
• The motor no longer
• Electrical power
activates
supply is not active
• Defective plug
• Defective motor or
control system
• Foreign object
• The motor is running
blocking motor
with a rattling noise
or hums without
• Defective motor or
running
control system
13
1-
2 - Remove the toilet bowl.
3 - Remove the casing and the hatch to access the
SOLUTION
4 - If a foreign body is preventing rotation, try to
• Remove the plug.
Wait an hour, then
plug back in
• Otherwise, call an ap
proved service
engineer
• Check the installation
upstream
• Clean or replace the
5 - If the non-return valve in the elbow
non-return valve
• Clear the vent
Information only for approved service engineers:
- Take off the toilet bowl
• Check the installation
- Disconnect the plumbing and electrical connections
• Otherwise, call an
- Unscrew the 4 bolts
approved service
engineer
- Pull the removable frame
- Unscrew the half-clamp
- Remove the macerator for repair or exchange
• Connect the unit to the
electricity
Once maintenance is complete, carry out the above
• Otherwise, call an
steps in reverse order.
approved service
engineer
• Remove the foreign
14
object
• Otherwise, call an
approved service
engineer
REMOVAL
DISCONNECT FROM THE POWER SUPPLY BE-
FORE PROCEEDING
HOW TO CHECK THE MACERATOR
DISCONNECT THE ELECTRICAL POWER SUPPLY
Turn off the toilet cistern tap. Bail out as much
water as possible from the toilet bowl siphon.
n
removable frame .
remove it through the hole of the toilet inlet seal
using a screwdriver or a piece of flexible wire (first,
remove the discharge sleeve
WARNING!
Never try to reach in with your hand to release
the cutters (extremely sharp blades).
remove the elbow from the soil pipe
it (if needs be, change the flap
valve which unlocks by turning) if necessary.
O
GUARANTEE
is guaranteed for 2 years subject to
SANIWALL
Pro
®
correct installation and usage as described in these
instructions.
l
).
Zf
is clogged,
Zg
, and clean
Zf3
by undoing the
n
m
Zj
Advertenties
Inhoudsopgave
