Safety When Handling Lead Acid Batteries; Intended Use - Dometic NDS Power Switch 100 Montagehandleiding En Gebruiksaanwijzing
Scheidingsrelais
Verberg thumbnails
Zie ook voor NDS Power Switch 100:
- Montagehandleiding en gebruiksaanwijzing (264 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
CAUTION! Explosion hazard
Do not place the battery in a area with flammable liquids or gases.
Never attempt to charge a frozen or defective battery. Place the battery in a frost-free area and
wait until the battery has acclimatised to the ambient temperature. Then start the charging
process.
Do not smoke, use an open flame, or cause sparking near the engine or a battery.
Keep the battery away from heat sources.
NOTICE! Damage hazard
Only use rechargeable batteries.
Prevent any metal parts from falling on the battery. This can cause sparks or short-circuit the
battery and other electrical parts.
Ensure that the polarity is correct when connecting the battery.
Follow the instructions of the battery manufacturer and those of the manufacturer of the system
or vehicle in which the battery is used.
If the battery has to be removed, first disconnect the ground connection. Disconnect all
connections and all consumers from the battery before removing it.
Only store fully charged batteries. Recharge stored batteries regularly.
Do not carry the battery by its terminals.
Safety when handling lead acid batteries
CAUTION! Health hazard
The water-acid liquid inside the battery can evaporate and cause an acidic odor. Use the battery
only in a well-ventilated area.
NOTICE! Damage hazard
The battery is not sealed. Do not turn the battery on its side or upside down. Place the battery
on a horizontal surface.
Check the acid level for open lead acid batteries regularly.
Immediately recharge deeply discharged lead acid batteries to avoid sulfation.
4
Intended use
The split charge relay is intended for connecting 2 lead acid (wet), gel, or AGM house batteries in parallel and
recording the input and output voltage as well as the current of the house batteries.
The split charge relay is suitable for the installation in any type of vehicle, e. g., RVs, CPVs, and boats.
The split charge relay is not intended for lithium batteries.
This product is only suitable for the intended purpose and application in accordance with these instructions.
This manual provides information that is necessary for proper installation and/or operation of the product. Poor
installation and/or improper operation or maintenance will result in unsatisfactory performance and a possible
failure.
The manufacturer accepts no liability for any injury or damage to the product resulting from:
• Incorrect installation, assembly or connection, including excess voltage
• Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
• Alterations to the product without express permission from the manufacturer
8
Advertenties
Hoofdstukken
Inhoudsopgave
