Inhoudsopgave
Advertenties
Warning
• When marking out the drill holes, make sure there are no electrical
wires or cables, pipes or other important components behind them!
If possible, work with a locating device (cable detector)!
Mounting steps
1. Disconnect the bracket (2) from the alarm body (1).
2. Hold the bracket at the mounting location on the wall and mark the two drill
holes (6).
3. Drill two ø 5 mm holes in the wall, then insert the plastic plugs (5) into the holes.
4. Attach the bracket to the plastic plugs and fix tightly the screws (4) into the plugs.
5. Fit the gas alarm on the bracket and pull it down until matching well on the
bracket.
6. Insert the power plug (3) into the socket.
3
7. A confirmation tone sounds and the "Power"-LED is flashing for about 3 minutes
2
4
5
6
– 20 –
Mounting
(Preheat).
8. When the "Power"-LED is constant on, the gas alarm is ready for use.
Status summary table:
Status
Self-test
Preheat
Standby
Test
ALARM
Silence
Sensor fault
End of life
Power off
Illustration
Green LED Yellow LED Red LED Horn
Power on
On
On
Ca. 3 minutes
Flashes
No
Normal condition
Shines
No
Press "Test"key
Shines
No
Gas detected
Shines
No
Press "Test" key
Shines
No
when Alarm
The detector must
Shines
Shines
be replaced
The detector must
Shines
Shines
be replaced
Power wire is
No
No
unplugged,
power failure
– 21 –
Status summery table
On
1x chirp
No
-
No
-
GB
Flashes
1x chirp
Flashes
Alarm
Flashes
-
No
1x chirp
once per
30 sec.
No
3x chirp
per 30
seconds
No
-
Advertenties
Inhoudsopgave
