Inhoudsopgave
Advertenties
will be on. Press the "ON/OFF" button, the appliance starts the self-cleaning.
3.
During self-cleaning mode, pump will draw water into ice making box, then ice making box rotates and pours
the water into water tank. This cycle will repeat for 5 times.
4.
Upon completion, the appliance automatically changes to standby mode.
5.
Empty the water tank. Leave the lid open to allow it to air dry.
Note: A small amount of neutral cleaner can be added into the water. The ratio shall be 1:0.05 (water: neutral
cleaner). When the cleaning is finished, rinse the appliance by repeating once or twice of above steps with clean
water.
CLEANING AND MAINTENANCE
1. Before cleaning and maintenance, turn off and unplug the appliance and allow it to warm up to room
temperature.
2. Clean the interior of the appliance with a soft cloth soaked with warm water and vinegar, then rinse with
clean water and then drain all the water. Replace the drain plug well in position.
3. Wash the ice cube basket and scoop in warm soapy water. Rinse and dry.
4. Clean the exterior of the appliance with a soft damp cloth.
5. The self-cleaning should be conducted before you use the appliance for the first time or haven't used it for
a long time. (See the "SELF-CLEANING MODE" section)
6. Please empty the water tank and dry it for storage if the appliance is not used for a long time.
Note:
1) Do not use organic solvent, boiled water, detergent, strong acid and strong alkali etc. for cleaning.
2) Do not clean the evaporator.
3) Do not immerise the appliance in water.
TROUBLE SHOOTING
Problem
Possible causes
"ADD WATER"
Low water level or lack of water
indicator lights on.
The filter at the bottom of water tank
is blocked.
Pump malfunction.
"ICE FULL" indicator
Ice cube basket is full. The infrared
lights up.
light-emitting diode or light-receiving
diode is blocked by the ice.
Infrared light-emitting diode and light-
receiving diode do not work.
"ADD WATER" and
The ice tray is not in the right
"ICE FULL" indicators
position.
Solution
Stop making ice, refill water and then press
"ON/OFF" key to restart.
Do cleaning.
Send for repair.
Remove the ice from ice cube basket.
Wipe up the foreign objects on the infrared light-
emitting diode and light-receiving diode; restart the
ice maker. Send the appliance to repair if the
Infrared light-emitting diode and light-receiving
diode still cannot work.
Unplug the appliance and check if the ice tray is
blocked by something.
- 7 -
Advertenties
Inhoudsopgave
