Inhoudsopgave
Advertenties
2. Open the lid and remove the ice cube basket and scoop.
3. Pour drinking water into the water tank. Pay attention do not over the MAX line.
4. Replace the ice cube basket and close the lid.
5. Plug in the appliance. The "POWER" indicator light will blink. Now the appliance is ready for use.
6. Press the "SELECT" button to choose the size of ice cube: "S" = Small; "L" = Large. The corresponding light
will be on.
7. Press the "ON/OFF" button, the appliance starts to work. The "POWER" indicator light will be constant on.
8. After about 7-15 minutes (depending on the ambient temperature or the water temperature), the first batch
of 9 ice cubes will be produced and dropped into the ice cube basket. You can also check through the
transparent window on the top.
9. The appliance will continue to make the next batch of ice cubes.
10. When you have got your desired amount of ice cubes, stop the ice making cycle by pressing the "ON/OFF"
button and unplug the unit from the wall outlet.
11. Open the top lid and transfer the ice cubes to a freezer.
12. Allow the appliance to reach the room temperature. Empty the water tank after each use.
Note! The produced ice cubes in the basket will melt gradually so please use the scoop to take out the ice cubes
in time. The melted water will be collected into the water tank.
Ice full indication
The "ICE FULL" indicator will light up when the ice cube basket is full and then the appliance will stop the ice-
making cycle automatically. Gently remove the ice cubes from the basket with the scoop. About 5 seconds later,
the appliance will restart its ice making function automatically.
Add water indication
The "ADD WATER" indicator will light up when the water tank is lack of water and the ice-making cycle will stop
automatically. At that time, remove the ice cube basket and add water to the water tank, and then press "ON/OFF"
button to restart the ice-making cycle.
The appliance will start working automatically after about 20 minutes if you forget to restart the appliance after
refill.
How to empty the water tank
Move the appliance forward to a place 60mm away from the working table (A) and open the drain plug (B) to
drain out excess water. You can use a container to catch the excess water. Then, replace the drain plug well in
position. (Fig. 4)
SELF-CLEANING MODE
This mode can help clean the interior of the appliance.
1.
Add water into the water tank. Do not over the Max line.
2.
Plug in the appliance, press the "SELECT" button to choose self-cleaning mode; the "CLEAN" indicator light
Fig. 4
- 6 -
Advertenties
Inhoudsopgave
