Inhoudsopgave
Advertenties
PLEASE NOTE: Read the safety and all other instructions that come with the cutting stand.
Failing to do so and disregarding the safety and all other instructions may cause injuries.
Keep these operating instructions for future reference in a safe place.
Dimensions assembled: 330 x 350 x 500 mm (width x depth x height)
Weight: 6.0 kg
Max. diameter of angle grinder: 530 x 130 x 150 mm (length x width x height)
Max. speed per minute: 8.500 (Ø 180 mm) / 6.600 (Ø 230 mm)
Diameter of cutting disc: Ø 180 mm / Ø 230 mm
This cutting stand is an aid for cutting work (exclusively for metal) with a one-hand angle grinder.
It is suitable for use with most angle grinders with a disc size of Ø 180 or Ø 230 mm. Carefully read
this instruction manual and especially the safety instructions before using the cutting stand.
Warning of general danger.
Wear a dust mask.
Wear safety goggles.
Wear ear protection.
Wear protective gloves.
Read instructions/information.
Pull out mains plug.
Do not use defective cutting discs.
t
Introduction
Technical data
Intended use
Symbols and meanings
9
Use for cutting only, not for roughing.
Exclusively for metal.
The grinder stand shall always
be mounted with screws on a work
bench.
Use only Ø 180 mm and Ø 230 mm
cutting discs.
The work piece shall be placed in
a suitable holder / between the
clamping jaws.
Warning of the rotating cutting disc!
To be used by one person only.
Do not use roughing discs.
Advertenties
Inhoudsopgave
