Inhoudsopgave
Advertenties
4
SPARE PARTS
If the device needs repairing, go to an
authorised assistance centre or manufacturer;
never try to repair it yourself.
5
TROUBLESHOOTING
The F2, F3 and F4 fuses are shown in the diagram of the page 53.
Problem
The gate does not make
any movement when a
key command is given
The gate does not open
(the display shows C4 or
C5)
The gate does not open
(the display shows C9)
The
gate
cannot
completely
close
(or
open)
Cause
Absence of system power supply voltage
F2, F3 or F4 blown
Emergency shutdown button open (the
display shows StOP)
Command devices defective
The transmitter is not programmed in the
control board
The transmitter batteries are flat
The interior or exterior safety device (photocells)
or its cabling is open or defective
Fuses blown
The safety strip or its cabling is open or defective
The safety device detects an obstacle
The operator force is too low (the display
shows F1 or F2)
Run not programmed correctly
MAINTENANCE AND TROUBLESHOOTING
Use only original spare parts.
Solution
Restore the power supply
Replace using another fuse of the
same value and investigate the cause
of the failure
C h e c k t h e p u s h b u t t o n a n d t h e
cabling
Check the respective guides
Programme the transmitter correctly
Replace the batteries
Check the cabling and the device
(photocells)
Replace using another fuse of the
same value and investigate the cause
of the failure
Check the cabling and the safety strip
Remove the obstacle and try again
Correctly programme the operator
force (A6)
Programme again
Control board VIVO-M203(M)
67
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
