Advertenties
LED light status
Not turn on
Green light on
Green light flashing
Red light flashing
Test the installation
► P. 9, fig. 19
Adjust the cutting height to its maximum level
(50mm) for first mow. Place your mower
inside the working area, work for a while, then
check boundary wire properly, check whether
the mower go back to the charging station
along the boundary wire. When the mower
successfully returns to the charging base, the
installation has been completed successfully!
Operation
Check before starting the device!
DANGER! Risk of injury! The
device may only be put into opera-
tion if there are no defects. If a part
is defective it must be replaced
before the device is used again.
Check to make sure the device is in safe
operating condition:
– Check to make sure there are no visible
defects.
– Check to make sure all device compo-
nents are correctly mounted.
Quick use robotic mower (Digital tube
Interface)
► P. 9, fig. 1
After the boundary wire installation, you can
start using the device.
Press [ ] until the device turns on. For the
first use, input the default PIN code 0000 by
pressing [OK] for four times when the num-
ber 0 is blinking.
Note: the device will turn off if it
does not receive any input within 30
seconds after it is turned on.
If you enter wrong PIN code ten times, the
device will raise a beeping alarm and then
turn off.
► P. 9, fig. 2
illustrate
There is no power
Boundary wire is con-
nected right; mower is
fully charged
Mower is auto charg-
ing
Boundary wire is not
connected; or bounda-
ry wire is breaking
Action
Confirm that the power cord is connected prop-
erly to the charger and that the charger is con-
nected to a suitable power supply.
Check the two ends of boundary wire connect-
ed the wire terminal is reliable.
Check the boundary wire is not break.
– Press [START], then press [OK] to start
mowing.
– Press [HOME] then [OK] the robot will
back to charging station.
the device will work continuously until reach-
ing low battery power level and then it will
return to the charging base. Once charging is
completed, the device will automatically
resume mowing or it stay in the charging base
according to the mowing schedule.
Setting
Change PIN code
► P. 9, fig. 3
To change the PIN code, keep press-
ing [START] and [HOME] buttons at the
same time for 3 seconds. The icon [ ] will
blink, [PIN 1] will flash, that means you need
to enter the old PIN. After the [PIN 1] is dis-
played, the first number will blink.
use [START] or [HOME] to select the num-
ber and press [OK] to confirm. The next num-
ber will blink. Use the same method to enter
your old PIN. Now you can set your new PIN.
For example, the new PIN code is set to be
1234. After enter your old PIN, [PIN2] will
flash and the first number will blink again. Use
the same method to enter your wanted new
PIN code (in this example, 1234).
Then [IDLE] will be on the display. Your PIN
code has been changed successfully.
Set year, date and time
► P. 9, fig. 4
Set year, date and time are compulsory set-
ting items. If you don't set these items, it will
influence the schedule time in the following
setting. These items should be set in the
order of year, date and time. For the year set-
ting, keep pressing [START] for 5 seconds
until the icon [ ] and a number are blinking
on the display, for example, 2020.
GB
53
Advertenties
Hoofdstukken
