Advertenties
• Do not put hands or feet near or under
rotating parts.
• Never pick up or carry the machine while
the motor is running.
• Do not leave the machine to operate unat-
tended if you know that there are pets,
children or people in the immediate vicin-
ity.
• Start the machine according to the
instructions standing well away from rotat-
ing parts.
• Do not use the product at the same time
as a sprinkler or use the schedule to
ensure that the two systems never run
simultaneously.
• If for any reason the product is sub-
merged, take it away from water and turn
it off using the isolator switch. Do not
attempt to switch the product on but con-
tact your vendor.
• Do not modify this product. Unauthorized
modifications may impair the safety of
your product and may result in increased
noise and vibration.
• Turn off the product using the isolator
switch:
– before clearing a blockage,
– before checking, cleaning or working on
the machine,
– before storage
– if the machine vibrates abnormally (stop
and check immediately),
– after striking a foreign object, inspect
the machine for damage and get advice
on necessary repairs from your vendor.
Maintenance and storage
• Ensure that all nuts, bolts and screws are
tightened and the tool is in a safe operat-
ing state.
• For safety reasons, replace worn or dam-
aged parts.
• Remember that when using a tool with
multiple blades, moving one blade may
lead to the other blades rotating.
• When adjusting the machine, make sure
that no fingers are trapped between the
moving blades and fixed parts of the
machine.
• Allow the motor to cool down before you
put the machine away.
• For safety reasons, replace worn or dam-
aged parts. Only use original spare parts
and accessories.
Your device at a glance
Note: The actual appearance of
your product may differ from the
illustrations.
► P. 3, fig. 1
1. Handle
2. Knob for cutting height adjustment
3. Control panel
4. Isolator switch
► P. 3, fig. 2
5. Drive wheels
6. USB port
7. Blade disc
8. Swivel castor
9. Blades
► P. 4, fig. 3
10. Base plate
11. Connection terminals for boundary wire
Scope of delivery
► Scope of delivery – p. 4
1. Robotic mower
2. Charging station
3. Ground pegs for charging station
4. Spare blade
5. Boundary wire
6. Ground pegs for boundary wire
7. Power supply for charging station
8. Distance gauge
• Operating manual
Installation
Note: Cut the grass before you
install the product, make sure that
the grass is maximum 5 cm.
Installation of charging Base
► P. 6, fig. 1
The charging base can be placed against
Near the tool house or house, when laying the
boundary wire, leave at least 1 m of straight
wire with no obstacles front of the charging
base.
– Put two guides on both side and put it on
the bottom and make the plate above the
guides, align the whole of guide and plate,
and then fix it by ground pegs.
GB
51
Advertenties
Hoofdstukken
