Inhoudsopgave
Advertenties
• Do the preliminary activities described in the operating and maintenance manual of the engine
mounted on the high pressure cleaner. In particular remember to fill with fuel and check the level of
engine oil.
• When the engine is off and the machine is completely cold, check the level of pump oil by way of the
level indicator (20).
When topping up is needed please refer to the lubricant types given in the
" paragraph.
data
• Check correct tyre inflation.
• Check that the inlet water filter (24) and the detergent suction filter (25) are clean.
• Take the high pressure cleaner to the place of work using the handle (4).
• Unwind the high pressure hose completely (28).
• Connect a gardening type quickfit coupling (not supplied) to the water inlet filter (24).
Operation G in Fig. 5.
• Start the engine, referring to the relevant operating and maintenance manual.
• Open the water supply tap (if connected to the drinking water mains it is mandatory to use a back-flow
preventer: to use this device refer to the relevant instruction manual), making sure there are no drips.
Alternatively, put a suction hose in a tank.
• Press the spray gun lever (31) and wait for a continuous jet of water to come through which means
the pump is priming correctly.
• Stop the engine, referring to the relevant operating and maintenance manual, and close the water
supply tap, if any.
• Press the spray gun lever (31) to discharge all residual pressure.
• Connect the lance hose (21) or (22) to the spray gun (19). Operation H in Fig. 5.
• Ensure that the nozzle holder head (23) or (34) is not in the detergent dispensing position (see also
"o
the
peratIon wIth detergent
• Start the engine, referring to the relevant operating and maintenance manual.
• Open the water supply tap, if any.
• Press the spray gun lever (31) checking that the nozzle spray is uniform and there are no drips.
• If necessary regulate the pressure by way of the pressure regulating knob (17). Turn it clockwise to
increase pressure, anticlockwise to reduce it. You can see the pressure on the pressure indicator (18).
• It is also possible to adjust the head (34) jet angle of the THERMIC 2W LITE 6L model from fan to
concentrated (see Fig. 4).
CAUTION
• Before expecting maximum performance of the high pressure cleaner it is good practice to warm
the engine up for a couple of minutes.
The recommended detergents are more than 90% biodegradable. On how to use the detergent please
refer to the instructions given on the detergent label.
• Put the hose (29) in the external tank which has already been prepared with detergent to the strength
required: in this case too, follow the indications given for the dosage on the detergent pack label.
• Turn the nozzle holder head (23) or (34) as schematized in Fig. 4-a and then operate the spray gun lever
(31) and start dispensing detergent.
• Release the lever (31) and turn the nozzle holder head (23) or (34) as schematized in Fig. 4-b to stop
dispensing detergent and return to high pressure operation.
20
OPERATION – PRELIMINARY ACTIVITIES
STANDARD OPERATION (HIGH PRESSURE)
" paragraph).
OPERATION WITH DETERGENT
"S
pecIFIcatIonS and technIcal
Advertenties
Inhoudsopgave
