Inhoudsopgave
Advertenties
EN
2.2.1. Programming the first 1W Somfy io control point for an LED light
1) Switch on the power supply.
2) Press the Up and Down buttons simultaneously on the 1W io
control point and follow procedure 2.2.1.1. or 2.2.1.2. according to
the reaction of the LED light(s).
2.2.1.1. An LED light comes on then goes out
Case 1: It is for this LED light that the control point must be programmed
• Briefly press the PROG button on this io control point.
The LED light comes on then goes out.
The io control point has been programmed for this LED light.
Case 2: It is not for this LED light that the control point must be programmed
• Press
the
Up
on
the
1W
necessary until the desired LED comes on then goes out.
͉
͉
If the output selected is not connected to any LED light, nothing
will come on. Select a different output.
• Briefly press the PROG button on this io control point.
The LED light comes on then goes out.
The io control point has been programmed for this LED light.
2.2.1.2. No LED light comes on
Press the Up button.
• If one or more LED lights come on:
The io control point has been programmed for the LED lights
lit.
- Go to section 2.3.
• If no LED light comes on:
check the status of the LED lights and the connection and
try again.
- Go to section 2.3.3.
2.2.2. Activating / deactivating automatic cut-off
͉
͉
Prerequisite: Commissioning has been completed using a 1W io control point.
This function allows an LED light to be switched off automatically after 3, 6 or 12 hours of operation.
It is possible to configure this period (see 2.2.3.).
4
and
Down
again
io
control
point
and
Copyright
©
2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
PROG.
simultaneously
repeat
if
PROG.
White LED Receiver io
ON
2.2.1.1.
2.2.1.2.
2.3.
2.3.3.
Advertenties
Hoofdstukken
Inhoudsopgave
