Inhoudsopgave
Advertenties
Translation of the original operating instructions
TRANSLATION OF THE ORIGINAL
OPERATING INSTRUCTIONS
Contents
About this handbook........................................ 11
Safety instructions............................................11
Designated use................................................ 11
Scope of delivery see Figure (1)......................11
Assembly.......................................................... 11
Operation..........................................................12
Maintenance and care..................................... 12
Repair............................................................... 13
Disposal............................................................13
ABOUT THIS HANDBOOK
Read this documentation before starting up
the machine. This is a precondition for safe
working and flawless operation.
Observe the safety warnings in this docu-
mentation and on the product.
This documentation is a permanent integral
part of the product described and must be
passed on to the new owner if the product is
sold.
SAFETY INSTRUCTIONS
Children, or other people who are not familiar
with the operating instructions, are not allo-
wed to use the machine
Observe local regulations regarding mini-
mum age requirements for operating the ma-
chine.
Observe local ordinances regarding opera-
ting times.
The equipment should be used only if in good
order and condition
The machine must not be operated if the ope-
rator is under the influence of alcohol, drugs
or medication.
Do not deactivate safety and protection de-
vices
DESIGNATED USE
The snow-clearing blade is only intended to be
mounted on a lawn tractor.
Snow-clearing blade part no. 119600 for trac-
tor
469588_a
Any use that is not in accordance with this desi-
gnated use shall be regarded as misuse.
SCOPE OF DELIVERY SEE FIGURE (1)
No.
Description
1
Swivel lever
2
Lifting lever
3
Lifting lever locking split pin
4
Mounting frame
5
Quick-acting coupling
6
Lift-off element
7
Folding split pin for swivel lever
8
Snow plough
9
Pin
ASSEMBLY
Removing the bumper (2)
1
Unscrew the rear hexagon head screws (A)
at both sides of the bumper attachment.
2
Loosen and remove the front hexagon head
screws (B) at both sides of the bumper at-
tachment, together with nuts and 2 washers
each.
3
Remove the bumper (C).
Installing mounting frame and quick-acting
coupling (3)
1
Secure the right and the left retainer of the
mounting frame with the following screws:
-
1x hexagon head screw M10 x 30 and
nut M10 (A).
-
1x hexagon head screw M8 x 25 and nut
M8 (B).
-
2x hexagon head screws M8 x 25, was-
her and nut M8 (C).
2
Secure the quick-acting coupling with two he-
xagon head screws M10 x 30, washer and
nuts M10 at the top bores in the mounting
frame retainers.
3
Secure the heat-conducting plate (E) with the
hexagon head screws M10 x 30, washer and
nut M10 at the bottom bores of the mounting
frame and the quick-acting coupling.
11
Advertenties
Hoofdstukken
Inhoudsopgave
