13.5 Installation of the appliance
13.5.1 Requirements for the installation:
Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
Ensure that the power cable does not hang down over a table or counter edge.
The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
Place the microwave appliance as far away from radios of TVs to minimize any
interference to radio and TV reception.
This appliance is only intended for domestic use.
This oven is intended for built-in use only. It is not intended for counter-top use or for
use inside a cupboard.
The appliance may only be operated when the door of the built-in furniture is open.
13.5.2 Electrical connection
DANGER: Risk of electrocution
► Touching internal compponents may cause serious, severe and fatal injuries.
► Do not disassemble the appliance.
► Improper grounding can cause electrical shocks. Do not use a power outlet if it is not
properly installed and grounded.
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
The electrical outlet must be protected by a 16A safety cut-out switch, separately from
other electricity consumers.
Make sure that the power cable is undamaged and has not been installed under the
oven or over hot or sharp surfaces.
This appliance must be electrically grounded. In case of a short circuit grounding will
protect against electric shocks because the electrical current is diverted through the
grounding lead. The appliance is fitted with an appropriate cable with a ground lead and
a grounded safety plug. The plug must be inserted into a properly installed and
grounded outlet.
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
58