Inhoudsopgave
Advertenties
shield mounting arm is mounted on the right of the
grinder.
Once eye shield mounting arms are firmly in place, slide
the shield bracket onto the eye shield-mounting arm.
Tighten the adjustable knob leaving it loose enough to
allow the safety eye shield to be raised and lowered
easily.
WARNING:
To prevent personal injury, never operate the bench
grinder unless the safety eye shields and spark deflectors
are properly installed and in place.
WORK REST
GB602/GB801/GB602W
See Fig. 7.
1
2
BASIC OPERATION
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing dust.
If operation is dusty, wear a dust mask.
To be efficient and work as designed, your tools should be
kept sharp. Dull tools can and will cause accidents.
Bench Grinders are ideal for sharpening tools such as
chisels, planer blades, scissors, etc., and for removing
rust or corrosion.
WARNING:
Never sharpen or grind anything made of aluminum.
Grinders remove material rapidly so pressure is the key to
efficient grinding.
The proper way to sharpen a tool and avoid overheating
is:
■ Keep a tool on the work rest firmly at the correct the
wheel.
■ Keep the object in constant motion, moving it at an
even pace.
■ Never force a tool against the grinding wheel.
■ Keep the tool cool by using either a cooling tray, or a
pan of water.
■ The grinding wheel should rotate "into" the object being
sharpened.
1. Work rest
bracket
2. Hex bolt
Fig. 7
OPERATION
Mount the work rests to the work rest bracket using the
two hex bolts.
Before tightening the bolts, adjust the gap between the
Grinding wheel and work rest to a maximum of 1.6 mm.
Tighten securely.
GB602W only
1
2
Mount the blade work rest to the work rest bracket using
the two hex bolts.
Before tightening the bolts, adjust the gap between the
Grinding wheel and work rest to a maximum of 1.6 mm.
Tighten securely.
NOTE:
Excessive pressure may damage the tool, cause the
motor to overheat, and prematurely wear down the
grinding wheel.
WARNING:
Excessive pressure on a cold wheel cause the wheel to
crack.
GB801 only
Balancing the grinding wheel
When the grinding wheel only is mounted, the heaviest
section will assume the lowest Position. Mark this section
as in the Fig. 9.
1. Work rest
2. Hex bolt
Fig. 8
Fig. 9
7
Advertenties
Inhoudsopgave
