Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5.6. Brushes
The brushes must be changed once they have worn down and are demonstrating only inadequate cleaning performance
on the animals.
Changing the brushes
1. Unfasten the screw on the brush and remove the clamping plate
2. Pull off the brush and replace with the new brush
3. Assemble the parts in reverse order. Secure screw with threadlocker.
Brush cleaning
The brush element should be cleaned every 6 weeks with a suitable disinfectant. (For example INTERKOKASK Spray
#299698 from Albert KERBL GmbH)
5.7. Entire machine
The entire machine must be cleaned on a regular basis.
The gears, motor and electrical components must not be cleaned with high-pressure cleaners.
Only clean the control box with a damp sponge / cloth!
Environmental note
Please observe local waste disposal regulations! Consult your local authority if you have any questions
concerning disposal options and quantities. Note the information in the product data sheet and/or the data
printed on each label.
6. Setup and spare parts list
Item number
Description
18892
Motor/transmission unit
18893
Complete control unit
18891
Spare brush, roll blue/red/blue
18893-2
Plastic housing for PCB/control unit
18893-1
Circuit board
18892-1
Motor terminal box, black
18893-3
Motion sensor
18893-4
Motor cable (control unit - motor)
18890-1
Brush shaft
18892-2
Motor capacitor 10 µF
18890-2
Ball bearings for pivot points
18890-3
Support plate for motor/gear unit
18890-4
Mounting for support plate
18890-5
Mounting arm for mounting
The machine may not be operated without a cover plug over the gre-
ase nipple on the brush bearing.
Figure 7 - lubrication points on the brush bearings
35
Advertenties
Hoofdstukken
Inhoudsopgave
