Suitable for induction cooking
34
Operation
4.10 Permanent pan recognition
If the hob has permanent pan recognition, a cooking setting can
only be directly switched on via the sensor fi eld after a pan has been
detected on the hob and the power display shows 0.
4.11 Operating the keys
The controls described here expect the pressing of a (selection) key
to be followed by the pressing of a subsequent key.
The next key will need to be pressed within 10 seconds, otherwise
the selection will be deleted.
4.12 Switching on the hob and cooking zones
1. Press the ON/OFF key
setting 0 appears and a short signal will sound. The controls are
ready for operation.
2. The sensor fi eld
immediately afterwards. A cooking level will be switched on.
......... left ..............cooking level 0
......... center .........cooking level 6
......... right ............cooking level P*
See the section on Worth knowing about the slider (sensor fi eld)
Press the respective sensor fi eld
level or to switch on an additional cooking zone.
3. Immediately put cookware suitable for induction cooking onto
the cooking zone. The pan recognition device will activate the
induction coil. The pot or pan will be heated up.
As long as no cooking pot is placed onto the cooking zone, the
display will alternate between the power level set and the symbol
. If no pot is placed on the cooking zone it will switch off after
10 minutes for reasons of safety. Please refer to the Section on
pan recognition.
Please note:
The permanent pan recognition recognizes on which cooking
zone a pan is set up and shows a 0 in the corresponding cooking
level display.
4.13 Switching off a cooking zone
4. a) Press the sensor fi eld on the far left
b) drag your fi nger to the left across the touch control
to reduce the power setting to 0
c) press the ON/OFF key
(all the cooking zones are switched off ).
4.14 Switching off the hob
5. Press the ON/OFF key
off , irrespective of any settings.
Please note:
The hob will switch off automatically after 10 seconds when all the
cooking zones are switched of manually (power setting 0) and no
key/sensor fi eld is pressed afterwards.
* The Power boost function is activated immediately. See the section
on Power boost.
(approx. 1 sec.) until the power
of a cooking zone must be activated
to change a cooking
or
. The entire hob will be switched off
. The hob will be completely switched
ENG