Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4
Operation
4.1
Switching ON /OFF
– Image A: in order to switch the appliance on, push the on/off switch 4 forwards.
– In order to switch the appliance off, push the on/off switch to position 0.
4.2
Comb attachment
– Image B: switch off the trimmer and push the comb attachment 11 onto the
cutter head 5 until it clicks into place.
– You can then cut hair with the trimmer as usual.
– Image C: the comb attachment 11 can be set to 4 different cutting lengths
(approx. 3 to 6 mm). To do this, push it to the desired position on the cutter
head 5.
The further the comb attachment
ting length.
5
Cleaning and care
To ensure perfect functioning and full performance of your trimmer, clean
and oil the appliance regularly.
Cleaning and oiling the cutter head
If you use the appliance regularly, the cutter head
cleaned and oiled
once a day
– Switch off the appliance.
– Remove the comb attachment 11, if necessary.
– Remove any hair using the cleaning brush 13.
– Image D: oil the areas where the bottom and top cutting blades touch.
20
ENGLISH
is pushed inwards, the shorter the cut-
11
should be thoroughly
5
.
Removing the cutter head
The cutter head
should additionally be removed
5
der to carefully remove residual hair particles from the interior using the
cleaning brush
.
13
– Ensure that the on/off switch 4 is set to 0.
– Removing: image E: press on the top of the cutter head 5 with your thumb to
push it off the appliance.
– Mounting: place the cutter head 5 on at the bottom and swing it upwards
until it clicks into place.
Replacing the cutter head
The cutter head
5
is a wear part. Despite good care, the cutting perfor-
mance will decrease at some point. Replace the cutter head when this hap-
pens. The cutter head can be ordered separately as a spare part from the
customer service centre. The address and telephone number of your near-
est customer service centre can be found on the back of these user instruc-
tions.
Cleaning the appliance
– From time to time, wipe the appliance with a slightly moistened cloth, then rub
dry.
Cleaning the charge contacts
If the charge contacts
on the appliance or the charge contacts
6
charging station
are dirty, the charging may be interrupted or obstructed.
2
– Clean the charge contacts 6 with a piece of cotton wool or cloth dipped in
alcohol or methylated spirit.
, in or-
at regular intervals
on the
1
Advertenties
Inhoudsopgave
