Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Charge the appliance's built-in battery exclusively using the original
accessory parts.
The appliance must only be operated with the original power supply unit
T10.
If the electrolyte solution leaks out of the battery, avoid contact with eyes,
mucous membranes and skin. Rinse immediately with plenty of clean
water and consult a doctor. The electrolyte solution can cause irritation.
he appliance contains a lithium ion battery.
T
– This appliance must not be opened!
WARNING! Risk of injury from cutting
Do not use the appliance with a damaged or fractured cutter head.
The cutter head must not be disassembled.
While the appliance is switched on, do not touch the cutter head.
The appliance must be switched off:
– when mounting or removing an attachment comb.
– when you put down the appliance, e.g. when you interrupt the cutting pro-
cess briefly.
– before removing or mounting the cutter head,
– before cleaning the appliance.
Use only the original attachment combs.
Do not use a damaged attachment comb.
ATTENTION! Risk of material damage
The cutter head is a precision part. Protect it against damage.
18
ENGLISH
In order to avoid increased wear of the cutter head and motor, the cutter
head must be cleaned and oiled regularly (see "Cleaning and care" on
page 20).
Do not use any sharp or abrasive cleaning agents.
The battery charger is fitted with non-slip plastic feet. As furniture is
coated with a wide array of varnishes and synthetics, and is also treated
with different care products, it cannot be fully ruled out that some of
these materials contain components that could attack and soften the
non-slip plastic feet. If necessary, place a non-slip mat under the appli-
ance.
Protect the appliance against heat (e.g. direct sunlight), chemical sub-
stances (e.g. perm agents) and mechanical damage (e.g. by dropping).
Specifications according to Machinery Directive 2006/42/EC
A-weighted emission sound pressure level at workstations at a distance of
1 m, L pA ≤ 70 dBA
measured maximum noise emission value, including uncertainty of measure-
ment according to EN ISO 4871. Determination of the values according to
EN 60704-2-9 with reference to EN 60704-1
Vibration total value to which the hand-arm system is subjected,
2
a h < 2.5 m/s
measured maximum vibration total value including uncertainty of measure-
ment. Determination of the values according to EN ISO 5349-1/2
Advertenties
Inhoudsopgave
