Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Attach both hanging brackets securely to the pre-mounted screws on the device with
the 2x2 nuts (A) supplied. The distance between the brackets is 60 cm.
• Screw both wall/ceiling supports loosely between the hanging brackets with the 2
screws (X) supplied.
• Secure the wall/ceiling supports using both small screws (Y) in the middle position.
• Select the location for the device, taking all of the instructions into account. Mark the
location for the 4 drilled holes on the wall/ceiling. Ensure that the device hangs
horizontally!
• Unscrew both wall/ceiling supports and secure them firmly to the marked location on
the wall/ceiling. Use wedge bolts for brick or concrete and ask for advice about
attachment materials for any other surfaces.
• Now secure the device firmly to the wall/ceiling supports with the hanging brackets
using both screws and bolts (X).
• The direction of heat from the device can be set to 3 positions. Only change the setting
if the device has cooled down completely and has been disconnected from the power
supply. Secure the direction of heat at the desired angle using both small screws (Y).
• Check to ensure that the device is hanging firmly.
• You are advised to ask an electrician to connect the device to the mains and then
operate via a switch. You could also connect an appropriate socket. Make sure that the
electrical cable never gets too hot!
Important! If secured to the wall, the heat can radiate straight out and also around 35°
downwards and upwards. Upwards is pointless and is also strictly forbidden! This could
overheat or melt the ceiling, lead to burn marks or even cause a fire. Water could also get
into the device.
Use
Check before each use:
- whether the device is showing any signs of damage.
- whether the device is still secured properly. Wind or gravity could loosen the
attachments over time.
34
Advertenties
Inhoudsopgave
