Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Temporary installation
As a temporary facility, the device can be directly connected to a socket via its electric
cable and plug. The device will then be switched on and off by inserting and removing the
plug from the socket (RC-version has on/off switch). Ensure that the electric cable does
not hang off sharp edges, is not twisted around sharp corners, cannot be dragged along
and does not come into contact with any hot surfaces.
Important: electrical cable and plug form one, single unit. If the electric cable or plug
becomes damaged, they must be replaced in their entirety by an electrician. Only allow
original parts to be used!
Location
The device must be installed with its lowest point at least 180 cm from the ground (A) for
both wall and ceiling installation.
The best efficiency will be obtained by placing the Outdoor heat panel horizontally against
the ceiling or roofing. If you mount the device on the wall, the efficiency reduces by a max.
40%.
The ideal position for the Outdoor heat panel is directly above the area/persons to be
heated. The maximum output point is located directly under the Outdoor heat panel; as
the distance increases, the temperature decreases.
When installing outdoors, under a roof covering, the most effective installation height is
between 220 and 270 cm. Never hang the device higher than 320 cm above the ground.
Ceiling installation:
Maintain a minimum distance to all side walls of 100 cm, see diagram (model may vary!!)
Also maintain a minimum of 1 metre around the device that is free from obstacles.
Wall installation:
Maintain a minimum distance to all side walls and ceiling of 20 cm, see diagram (model
may vary!!) Also maintain a minimum of 150 cm around the device that is free from
obstacles.
Ceiling installation:
Wall installation:
32
Advertenties
Inhoudsopgave
