Download Inhoudsopgave Inhoud Print deze pagina

Important Tips; If Unexpected Difficulties Arise - Thomas BOXER Gebruiksaanwijzing

Verberg thumbnails Zie ook voor BOXER:
Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 22
N Snap the spray hose (18) into the quick coupling (5) on the
motor block.
O Fit the carpet spray extraction nozzle (17) onto the suction tube.
P Close the spray tube (12) of the spray nozzle using the quick-
action coupling on the handle. To do this, hold the free end of
the spray tube of the spray nozzle. Place this on the stop valve
of the spray lever. Lock it by turning the bayonet catch to the
right. Fasten the two retaining clips for the spray tube (39) to
the telescopic wand. Clip the spray tube into the retaining clips.
Connect the mains cable.
N Switch on the appliance with the On/Off (6) switch. Switch on
the enlightened pump switch (7).
P Press the lever of the stop valve (16) on the handle.
Cleaning fluid spray will begin.
Before refilling the cleaning fluid tank, always
empty the dirty water from the collecting bin.
Cleaning hard floors
Q Assemble hard floor adapter.
See "Carpet cleaning" procedure.
We recommend THOMAS ProFloor cleaning concentrate for
cleaning hard floors.
Cleaning upholstery
For cleaning your upholstery or car seats, please use the upholstery
spray extraction nozzle (23).
Take care not to apply too much liquid; depending on the
upholstery sublayer, you may experience significant drying
times.
R Assemble the upholstery spray nozzle. Fasten the cleaning fluid
hose by turning it. Fit the nozzle onto the handle.
Cleaning and care of the spray extraction system
K To care for the pump and valves properly, fill the
cleaning fluid tank with clear water and insert it.
Connect the mains cable. Switch on the On/Off
switch (6) as well as the pump switch (7).
P Operate the spraying system, e.g. over a sink
(disengage the lever of the stop valve (16)).
N Before removing the cleaning fluid hose, engage the lever
of the cut-off valve (16, figure P) in order to release the
remaining pressure in the system, and then press the key on the
quick coupling (5).
Remove the power cord!
Afterwards, clean and dry the appliance and the accessories you have used.
Never dip the motor block in water!
Clean the housing cover of the motor block casing with a damp cloth
and wipe dry.

Important tips

When wet vacuuming, always vacuum by drawing the carpet
spray nozzle in straight parallel strokes across the surface
towards you.
In order to avoid soiling the carpet again, you should not
walk on shampooed carpets until they have dried.
In order to achieve quicker drying of shampooed surfaces, it
is helpful to remove residual liquid remaining in the carpet by
vacuuming it again – without engaging the valve hook.
When cleaning parquet floors, please observe the instructions
of the parquet floor manufacturer.

If unexpected difficulties arise

If your appliance does not operate to your satisfaction, you do not
have to contact customer service straight away. Please check first as to
whether the fault is due one of the following minor causes:
Dust escaping from suction sockets:
- Has the filter system been fitted in accordance with the
instructions?
- Has an original THOMAS filter been used?
Gradual reduction in suction power:
- Are the pores of the tissue filter clogged up by dust or soot?
- Is the collecting bin or the paper filter bag full?
- Is there a blockage in the nozzle, extension tube or flexible
hose?/Stretch the flexible hose while the appliance is switched
on – this will loosen the obstruction.)
15

Advertenties

Inhoudsopgave
loading

Inhoudsopgave