Download Inhoudsopgave Inhoud Print deze pagina

Pan Detection; Power Level Setting - ETNA KIV164 Series Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

USE
Minimum pan diameter
The diameter of the bottom of the pan must be at least 14 cm.
You will achieve the best results by using a pan with the same diameter as the zone.
If a pan is too small the cooking zone will not work.
Attention
Grains of sand may cause scratches which cannot be removed. Only put pans with
a clean bottom on the hob. We recommend that you lift pans and not slide them
over the hob.

Pan detection

If the hob does not detect a (ferrous) pan after a power level has been set, the pan detection
symbol flashes in the display. After 1 minute the cooking zone switches off.
If you remove a pan from the cooking zone during cooking, the pan detection symbol
shows. The cooking zone switches off. The symbol disappears when you put the pan back.
The cooking zone switches on again with the power level that was set before.

Power level setting

The cooking zones have 9 power levels. If you have switched on the hob the required cooking
zone can be chosen within the next 60 seconds. Set the power level by touching the plus (+) or
minus (-) key.
EN 9

Advertenties

Inhoudsopgave
loading

Inhoudsopgave