Section 3: Receiver Programming; Enroll & Program Devices; Identified Wireless Keys; Opening/Closing By Wireless Key Reporting - DSC PowerSeries RF5132-433 Installatiehandleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Enroll & Program Devices

This section describes how to enroll and program:

• Wireless devices using zones

• Wireless keys

For more information on these devices, read the instruction sheet included with each device.

3.1 Identified Wireless Keys

Reporting by the system of openings/closings by individual wireless keys and command output [

wireless key buttons may be supported on certain control panels. To do this, the system will reserve access codes 17 –

32 for wireless keys 01-16 respectively. You must program one access code for each wireless key (using [

code programming) for this feature to work correctly.

NOTE: Program the access codes on the system after you have connected the RF5132 to the Keybus (see section 2.4).

Refer to your system Installation Manual for information on access code programming.

Opening/Closing By Wireless Key Reporting

NOTE: The Identified Wireless Key Closing option is only available with the PC5020, PC1616, PC1832, PC1864,

PC501X v2.0 and higher, PC1555(MX), PC580/585 v2.0 and higher.

To enable the reporting of openings and closings by identified wireless keys:

• Make sure the control panel is v2.0 or higher

• Program a valid access code for each key

• Program a closing and opening reporting code for each key's access code

• Turn off the Quick Arm option in section [015] option [4] of the control panel programming

To ensure that an unidentified wireless key cannot disarm the system, turn off section [017], option [1] (in the control

panel programming). This option is available in control panels with software

3.2 A Note about Electronic Serial Numbers (ESN)

An electronic serial number (ESN) is printed on each wireless device. ESNs are used to enroll the wireless devices with

the RF5132 receiver.

In order to reduce the occurrence of wireless devices with the same serial number, 6-digit serial numbers are printed on

the back of each wireless device. The 6-digit serial numbers include hexadecimal digits. For instructions on

programming hexadecimal numbers, see your system Installation Manual, Section 4: How to Program.

NOTE: 6-digit serial numbers are only supported on the following control panels: PC5020, PC1616, PC1832, PC1864,

PC501X v2.0 & higher, PC1555(MX), PC580/585.

3.3 Enroll Wireless Devices Using Zones

Enroll wireless devices which use zones (universal transmitters, motion detectors, smoke detectors, and panic

pendants):

1. At a system keypad, enter [

2. Enter programming section [804].

3. Enter the 2-digit number corresponding to the zone the device is to occupy ([01] to [32]).

Hardwired and wireless devices cannot be assigned to the same zone. PC5108 zone expander modules

NOTE:

occupy zones in 2 groups of 4 (e.g., zones 9-12 and zones 13-16). None of the zones assigned to a PC5108