Inhoudsopgave
Advertenties
6. The magnetic temperature sensor
• The temperature sensor comes with the heater
and can be reordered as spare part.
• The magnetic temperature sensor must always be
used when heating in "temperature mode"
• The sensor can be used as a tool for temperature control whilst
heating in "time mode"
• The sensor is suitable for a maximum temperature of 240ºC (464°F).
• In the event of temperatures exceeding 240ºC (464°F), the connection between
the magnet and the sensor is interrupted. The heater switches off automatically
when the sensor does not detect a temperature increase.
• Special clamp sensors are available for non-magnetic workpieces.
• Make sure that the sensor and workpiece surfaces are clean.
• Always place the sensor on a flat area as close as possible to the bore. Connect the sensor
by inserting the plug into the socket (in the casing). Make sure that the – and + of the plug
correspond to that of the socket.
CAREFULL!
Handle the sensor with care! It is a vulnerable part of the heater. After use, place the
sensor on the side of a vertical pole. Remove the sensor from the workpiece at the plastic
part. Do not pull the cable.
14
© BETEX Tools
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
