Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Fan Only Mode
For fan only mode, turn the power and fan control dial to FAN MODE.
Switching Off
1.
Turn the power and fan control dial to the OFF position.
2.
Turn the temperature control anticlockwise to the lowest setting.
3.
Remove the power plug from the power socket.
Overheat Protection
If the heater overheats, the thermostat built into the appliance will automatically cut off the
power supply to the heater and the heater will turn off. The heater will need to cool down for 10-
20 minutes. One the heater has cooled down it can again be used normally. Overheating of the
appliance can occur during improper use or in certain environmental conditions.
Tip-over Protection
When the heater is knocked over or tipped onto its side, the safety switch will automatically cut
off the power supply to the heater. Power will return to normal when the unit has been placed in
an upright position and onto an even surface.
CLEANING AND STORAGE
― ―
WARNING: ALWAYS TURN THE HEATER OFF, UNPLUG THE
POWER CORD FROM THE ELECTRICAL OUTLET AND ALLOW
THE APPLIANCE TO COMPLETELY COOL DOWN BEFORE
HANDLING OR CLEANING IT.
WARNING: ALLOW THE HEATER TO COOL DOWN FOR 2
HOURS (120 MINUTES) BEFORE CLEANING.
CAUTION: DO NOT ALLOW WATER OR OTHER LIQUIDS TO
RUN INTO THE INTERIOR OF THE HEATER, AS THIS COULD
CREATE A FIRE AND/OR ELECTRICAL HAZARD.
CAUTION: DO NOT USE ANY ABRASIVE CLEANERS OR
SOLVENTS, AS HEATER DAMAGE WILL OCCUR.
•
Do not attempt to clean the heater in any other way than
that detailed by the manufacturer.
•
Clean the exterior surface of the heater by wiping it with
English | 9 of 83
Advertenties
Inhoudsopgave
