Advertenties
Beschikbare talen
Beschikbare talen
Let it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
Always lead the mains and extension cable as well as the extraction
hose to the back away from the machine.
Power tools have to be inspected by a specialist in regular intervals.
Never carry the machine at its cable.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
During use, the operator and other persons standing nearby have
to wear suitable ear protectors, a dust mask, safety goggles and
protective gloves.
Make sure that persons in the work space are not endangered by
particles flying around.
Keep the handles dry, clean and free of oil and grease.
During operation, always hold the tool with both hands.
Attention! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
Before starting the machine check the correspondence between voltage
and frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed. The grinder is
made in protection class II. Only use extension cables with a sufficient
cross-section. A cross-section which is too small could cause a
considerable drop in performance and an overheating of machine and
cable. The tool includes a start-up speed limiter to prevent fast expulsion
fuses from unintended responding.
Switching on and off
Short-Time Operation
Switching-on:
press the on/off switch twice within 2 seconds
Switching-off:
release the on/off switch
Permanent Operation
Switching-on:
press the on/off switch twice within 2 seconds and, keeping
it pressed, engage the lock-on button
Switching-off:
press the on/off switch and release it again
Electrical Connection
16
Advertenties
