Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The cleaning water must not get into
the following areas:
Controls
■
Illumination
■
Ventilation openings
■
Openings in the separating plate
■
Proceed as follows:
1. Pull out the mains plug or switch off
the fuse.
2. Take out the frozen food and store
in a cool location. Place ice pack (if
available) on the food.
3. The rinsing water must not drip into
the controls, lighting, ventilation
openings or the openings in the
partition!
Clean the appliance with a soft cloth,
lukewarm water and a little pH-neutral
washing-up liquid.
4. Wipe the door seal with clear water
only and then wipe dry thoroughly.
5. After cleaning reconnect the
appliance.
6. Put the frozen food back into
the appliance.
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out shelves in the door
Fig. $
Lift shelves upwards and take out.
Take out glass shelves
Pull the glass shelves forwards and take
out.
Removing the container
Fig. (
Pull out the container all the way, lift at
the front and remove.
Taking out the frozen food container
Fig. *
Pull out the frozen food container all
the way, lift at the front and remove.
Light (LED)
Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.
Tips for saving energy
Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
■
possible.
To achieve the lowest energy
■
consumption, leave a small wall gap
at the side.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.
en
41
Advertenties
Inhoudsopgave
