Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guidesbox.com
Handling and use
Fitting the car cradle
Unscrew the screw ring 4 anticlockwise from the
♦
car cradle .
Place the screw ring 4 over the ball joint 9 and
♦
press the ball joint 9 into the ball joint socket 5
(see fig . C) .
Screw the screw ring 4 clockwise onto the ball
♦
joint socket 5 until tight
Fitting the vent clip
Pull the lever 1 towards the car cradle and hold it
♦
in place .
Guide the hook 2 between two ventilation slots
♦
and hook it onto a ventilation slot .
Release the lever 1 slowly and, at the same time,
♦
place the two cut-outs 3 onto a ventilation slot .
Align the car cradle so that the two arms of the vent
♦
clip rest on the fitting . You can use the 360° rotating
ball joint 9 to adjust the car cradle horizontally
and vertically to suit your requirements . Loosen the
screw ring 4 a little to make it easier to adjust the
ball joint 9 .
TKHU 2 A2
GB │ IE
│
13
■
Advertenties
Hoofdstukken
Probleemoplossen
