Adjusting The Boiler To The System; Changing Parameters At User Level (Without Access Code) - REMEHA GAS 210 ECO PRO Gebruikershandleiding
Verberg thumbnails
Zie ook voor GAS 210 ECO PRO:
- Handleiding (74 pagina's) ,
- Installatie-, gebruikers en servicehandleiding (72 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GAS 210 ECO PRO
3 .3
Adjusting the boiler to the system
2x
2x
fig. 03
Changing parameters
27102015 - 114500-06
• Press the [+] key again until pr appears alternating and, for
example, 3.0 bar, the actual water pressure (if no water pres-
sure sensor is connected, --.- bar appears);
• Press the [+] key again until p appears and, for example,
78 %, the actual modulation percentage;
• Press the [+] key again, the read-out cycle starts again with
5t, etc;
• Press the
current operating status.
The boiler's control unit is set to the most common central heating
systems. With these settings, practically all central heating sys-
tems will work well. However, the user or the installer can optimise
the parameters as he/she wishes.
3 .3 .1
The following settings can be changed at user level:
p1 = Maximum flow temperature [°C], adjustable between
p 2 = Pump post-circulation time 0..98 mins, 99 is continuous;
p 3 = B oiler control; central heating on/off.
p 4 = Display
The parameters can be changed at user level as follows:
1. Press the -key several times until the s ymbol flashes in
the menu bar;
2. Select the users menu using the -key, p1 appears (the
1 flashes);
3. Press the [+] -key; p2 appears (the 2 flashes);
4. Press the -key again; 3 (min) appears and flashes: (factory
setting);
5. Change the value by pressing the [-] -key or the [+] -key, in this
case for example to 15 min, with the [-] -key;
6. Confirm the value with the -key, p2 appears (the 2 fla-
shes);
7. Press
ting status.
114492LTAL21H021b
The p1 to p4 settings can be changed in the same way as
p2.
key twice to return to the display with the
Changing parameters at user level (without
access code)
20 and 90°C;
0 = Central heating
off
1 = Central heating
(= factory setting)
on
0 = Simple display
1 = Comprehensive display
2 = Display automatically goes to simple after
three minutes (factory setting)
-
t he
key twice, the boiler enters the current opera-
3. Control
27
Advertenties
Inhoudsopgave
