Advertenties
Beschikbare talen
Beschikbare talen
Transport and storage
Transport of cordless power tools and batteries
CAUTION
Accidental starting during transport !
Always transport your products with the batteries removed!
▶
Remove the battery/batteries.
▶
Never transport batteries loose and unprotected. During transport, batteries should be protected
▶
from excessive shock and vibration and isolated from any conductive materials or other batteries
that may come in contact with the terminals and cause a short circuit. Comply with the locally
applicable regulations for transporting batteries.
Do not send batteries through the mail. Consult your shipper for instructions on how to ship
▶
undamaged batteries.
Prior to each use and before and after prolonged transport, check the product and the batteries for
▶
damage.
Storage of cordless power tools and batteries
WARNING
Accidental damage caused by defective or leaking batteries !
Always store your products with the batteries removed!
▶
Store the product and the batteries in a cool and dry place. Comply with the temperature limits
▶
stated in the technical data
Do not store batteries on the charger. Always remove the battery from the charger when the
▶
charging operation has completed.
Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶
Store the product and batteries where they cannot be accessed by children or unauthorized
▶
persons.
Prior to each use and before and after prolonged storage, check the product and the batteries for
▶
damage.
Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed
Status indicators of the Li-ion battery
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem
by yourself, contact Hilti Service.
Trouble or fault
The product cannot be
switched on.
The battery runs down
more quickly than usual.
The battery does not en-
gage with an audible click.
The motor has no braking
effect.
*2412886*
25.
24.
Possible cause
Battery is discharged.
Very low ambient temperature.
The retaining lug on the battery
is dirty.
Battery is discharged.
Product is momentarily over-
loaded.
2412886
Action to be taken
Change the battery and charge
▶
the empty battery.
Allow the battery to warm up
▶
slowly to room temperature.
Clean the retaining lug and
▶
re-insert the battery.
Change the battery and charge
▶
the empty battery.
Switch the product off and
▶
then on again.
30
Advertenties
