Advertenties
Beschikbare talen
Beschikbare talen
Positioning pins
Q
Battery release button
W
Intended use
The product described is a cordless rebar flush cutter. It is intended for flush cutting or free cutting
rebars, mild steel threaded rods, galvanized mild steel threaded rods and stainless steel threaded
rods used in the construction industry.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum
performance, Hilti recommends the batteries stated in the table at the end of these operating
instructions for this product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
Items supplied
Rebar flush cutter, side handle, saw blade, blade cover, hex key, chip collection bag, operating
instructions
Other system products approved for use with this product can be found at your local Hilti Store or
at: www.hilti.group
Motor protection function
The motor protection function monitors current consumption and motor temperature and prevents
the product from overheating.
If the motor is overloaded through application of excessive working pressure, the product's
performance drops noticeably or it might stall completely.
If the power tool stalls or slows significantly due to overloading, relieve the pressure applied to
the product and then allow it to run under no load for approx. 30 seconds.
Status indicators of the Liion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of
health.
Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
If the release button is pressed with a battery inserted in the product, subsequently check that the
▶
battery is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following status indications is
applicable at the time.
State of charge and, if applicable, faults are indicated constantly as long as the connected product
is switched on.
Status
Four (4) LEDs show constantly green
Three (3) LEDs show constantly green
Two (2) LEDs show constantly green
One (1) LED shows constantly green
One (1) LED slow-flashes green
One (1) LED quick-flashes green
*2412886*
2412886
Battery status indicator
E
Meaning
State of charge: 100 % to 71 %
State of charge: 70 % to 51 %
State of charge: 50 % to 26 %
State of charge: 25 % to 10 %
State of charge: < 10 %
The Li-ion battery is completely discharged.
Recharge the battery.
If the LED again starts quick-flashing after the
battery has been charged, consult Hilti Service.
24
Advertenties
