Advertenties
Beschikbare talen
Beschikbare talen
As drop arrester for this product, use only a combination of the Hilti retaining strap #2293133 and
the Hilti tool tether #2261970.
Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
▶
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool
tether.
Installing or removing the chip collection bag
1.To install, push the adapter of the chip collection bag on to the chip collection bag holder until it
engages with an audible click.
2.To remove, open both clamps on the adapter of the chip collection bag slightly outwards.
Installing side handle
Screw the side handle into one of the threaded holes.
▶
Adjusting opening width
1.Loosen the width adjusting screw.
2.Move the width adjusting block left or right to obtain the desired opening width.
Operation
Observe the safety instructions and warnings in this documentation and on the product.
Switching on
CAUTION
Risk of injury Loss of control over the product.
Before operating the product, check that the side handle, clamping flange, blade cover and the
▶
screws retaining the saw blade cover and all other screws are secure.
1.Press the rear section of the on/off switch.
2.Slide the on/off switch forward.
The motor runs.
▶
3.Lock the on/off switch.
4
Cutting rebar
WARNING
Risk of injury Incorrect placement or cutting speed can cause serious injury and damage to the
motor's electronics.
When cutting, slow down the forward (cutting) movement both at the start and approaching the
▶
end of the cut.
Hold the product firmly so that it does not vibrate when cutting.
▶
Do not start cutting immediately after the motor is switched on. Allow the saw blade to reach full
▶
speed before starting the cut.
Do not touch the rotating parts as they can cause serious injury.
▶
Do not cut rebar with a diameter of less than 4 mm.
▶
Do not cut rebar less than 10 mm in length, as the off-cut can stick between the saw blade and the
▶
cover which can cause damage and possibly serious injury.
1.Check that the switch is at the O position (1).
2.Choose the most suitable setting for the intended cut (2).
Select setting 6 for highest cutting speed. Select a lower setting to reduce sparking.
3.Switch on the product.
4.Fit the rebar tightly against the guide. Slowly ease the product forward to start cutting the rebar (4).
*2412886*
28
2412886
28
Advertenties
