Download Inhoudsopgave Inhoud
Deel
Print deze pagina
  1. Handleidingen
  2. Merken
  3. Chamberlain Handleidingen
  4. Deuropeningssystemen
  5. my Q CHSL400EVC
  6. Installatiehandleiding

Stand-By Mode - Chamberlain my Q CHSL400EVC Installatiehandleiding

Verberg thumbnails
Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 38
7. PROGRAMMING
NOTE: To stop Learning phase press "S" button. The Learning process will be
interrupted, "LE" will flash on LED display. After 5 seconds "LL" will appear on
display indicating readiness to start Learning phase again.
If Learning process was not completed, it needs to be re-done.
ATTENTION: Learning phase must be completed to enable operation.

7.5 Stand-by Mode

After the control board is powered on and programming is finished, the LED display
lights completely for 2 seconds and goes into the stand-by mode. During Stand-by
mode the LED display shows current gate status.
Motor is opening, upper section of the display flashes.
Motor stops at the opening position on the limit switch, upper
section of the display is on.
Motor is closing, lower section of the display flashes.
Motor stops at the closed position on the limit switch, lower
section of the display is on.
Motor stops in the middle, middle of the display is on.
Herewith the Basic Settings are completed. You can leave Programming
and operate your gate or proceed with Advanced Settings.
S
One motor
11
P
+
5 sec.

Advertenties

Inhoudsopgave
loading

Gerelateerde Handleidingen voor Chamberlain my Q CHSL400EVC

Gerelateerde Producten voor Chamberlain my Q CHSL400EVC

Inhoudsopgave