Advertenties
Beschikbare talen
Beschikbare talen
switch it to lower zone. Setting temperature could only be set under display flash status.
• You can touch key "+" (C) and key "-" (B) to set the internal temperature for the selected zone. The
degrees indicators will appear in the display window marked
• When the unit is plugged in for the first time, the LED readouts will show the original temperature set
previously. Touch the "+" (C) and "-" (B) mark once of each compartment to set the desired
temperature.
• The temperature will increase by 1°C or 1ºF if you touch the "+" (C) mark once, or the temperature will
decrease by 1°C or 1ºF if you touch the "-" (B) mark once.
Temperature display
To view the set temperature in either zone at any time, touch key H ,display will switch to setting temperature
with one zone flashing and the other one no flashing.
5 seconds later without operation. Then the display turn to current inner temperature again.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature setting on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to wait
5 minutes before turning it on again.
Temperature alarm
The alarm will sound and the temperature display will flash when:
-
The temperature in one of the zones rises or falls outside the temperature range (5-12°C or 12-
20°C)
-
You switch the appliance on, if the temperature inside the appliance is very different (+/- 4°C)
from the temperature set after 7 hours working
-
Too many items have been put into the unit at one time, and the temperature inside the appliance
is very different (+/- 4°C) from the temperature set after 7 hours working
-
The door has not been closed tightly
When the surrounding temperature is 25℃ and the wine cooler has no bottle loaded, it will take
around 12 minutes to increase the wine cooler's temperature from 5℃ to 12℃. Under the same
circumstance, it will take around 25 minutes to decrease the wine cooler's temperature from 12℃ to
5℃. The less the temperature span is, the less time it will take. The setting temperature of upper
zone should be lower than the setting temperature of lower zone
Door alarm
If the door has been left open for more than 60s, the alarm will sound. Once the set temperature has been
reached in the appliance, the alarm stops and the relevant temperature display stops flashing.
However, if the noise disturbs you, you can switch the alarm off before this if you wish by pressing the key I
once. The alarm will stop. The relevant temperature display continues to flash until the set temperature has
been reached. The display then lights up constantly and the alarm system is fully active again.
Interior light
The interior light makes it easy to view your wines labels and enhances the display of your collection.
Touching the
mark (J) toggles between two modes of operation for the internal lights:
-
Functional mode (default): the light will turn on only when the door is open, this is the most
economic mode
-
Showcase mode: the lights will be on whether or not the door is open. To turn this permanent light
mode and get back the default mode, please push again the light button
Dynamic climate / silent mode
for upper zone and
(J).
for lower zone.
60
Advertenties
