Advertenties
Beschikbare talen
Beschikbare talen
Possible faults
Before each fault clearance
Switch off device
Wait for standstill of the saw blade
Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after
switching on or switches off
during idle running
No crosscut function
Saw blade jams while
cutting
Saw blade jams while
cutting
Burned spots at the cut
areas
Saw vibrates
Chip outlet is clogged
Rotary table moves hard
In case of further faults or inquiries please contact your local dealer.
Technical data
Typ
Year of constructions
Motor input P
1
Mains voltage
Mains frequency
No-load speed
Saw blade diameter
Saw blade hole
min. tooth width
Number of teeth
Mitre left / right
Incline angle left / right
Max. cross-section of work piece (height x width)
Straight cuts:
Mitre cuts (rotary table 45°)
Inclined cuts (saw head 45° to the left)
Double mitre cuts (rotary table 45°/saw head 45°)
Exhaust connection
Dimensions (length x breadth x height)
Weight
Commercial small dust removers or industrial vacuum cleaners can be used for exhaustion.
20
Possible cause
Power failure
Extension cable defect
Motor or switch defect
Transport locking pin not removed
Locking device for pendulum
cover not opened
Saw blade is dull
Feed is too great
Saw blade is dull
Saw blade is not suitable for the
work step or is dull
Saw blade is warped
Saw blade not properly mounted
No exhaust system connected
Exhaust power too weak
Chips under rotary table
Removal
Check safety fuse
Check cable, no longer use defect cable
Have motor or switch checked by an approved electrician or
replaced by original spare parts
Pull out transport locking pin (5)
Open locking device (17)
Replace saw blade (36)
Allow motor to cool and proceed working with less pressure
Hold the work piece firmly and cut off the motor immediately.
Replace then the saw blade.
Replace saw blade
Replace saw blade
Mount saw blade properly
Switch off saw, remove chips and connect exhaust system
Switch off saw, remove chips and increase exhaust power
(air velocity 20 m/sec at chip exhaust neck.
Remove chips
KGSZ 305 N
see last page
2100 W
230 V~
50 Hz
4000 min
–1
305 mm
30 mm
2.8 mm
60
0 – 45 °
0 – 45°
100 x 330 mm
100 x 220 mm
55 x 330 mm
55 x 220 mm
44
approx. 660 x 425 x 530 mm
approx. 16 kg
Technical modifications reserved!
Advertenties
