Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3
Close design cover.
Result
✓ The LED on the lateral control panel lights up
blue.
✓ The device is ready for operation.
If the status LED flashes red:
• Test whether the water supply has been
established. Open ball valve.
• Reset storage water heater. → See
"Resetting the storage water heater",
page 44
• switch off device, wait 30 seconds and
then switch device back on.
If the status LED continues to flash red after
taking these measures, contact customer
service.
162129588743651083 © 03-2022
970.058.00.0(01)
Putting the remote control into
operation
If several devices of the same type are
installed in immediate proximity (e.g. in
hotels), remote control must be assigned.
→ See "Re-assigning the remote control",
page 40.
Prerequisite
– Function test of the device was performed
successfully.
▶
Open the battery compartment and insert
battery.
Result
✓ The display shows [Pairing ok] for 10 seconds.
If the [Pairing ok] message does not appear,
re-assign remote control. → See "Re-
assigning the remote control", page 40.
EN
39
Advertenties
Inhoudsopgave
