Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
not hang anything on the heater and do not cover it while it's working.
This is clearly written on the cover of the product or shown by the sym-
bol
• Do not use the product in rooms saturated with explosive gas, vapours
generated by solvents or paints or flammable vapours/gas.
• If the cable and/or plug are damaged, do not repair them yourself but
take the product to the technical service or a qualified repair centre and
have them repaired by specialised personnel in order to avoid any risk
of damage.
• Always position the product so that the plug is immediately accessible.
• Never position this appliance immediately underneath a power socket.
• Do not insert objects or paper into the radiator.
2. Your product
•
Other than the heater you have chosen the package includes (picture 1):
- N° 1 metal brackets for wall mounting (fixed to the radiator);
- N° 4 nylon plug expansion 8x50mm;
- N° 4 5x60mm cross head screws to fix wall brackets;
•
Refer to your dealer is something is broken or missing.
•
Depending on the purchased model, the product may or may not be equipped with Wi-Fi connectivity. If it does not have
one, it is possible to purchase the optional Wi-Fi module and install it with a few simple operations.
3. Safe positioning
•
Only use the product in its horizontal position;
•
This product is fitted with a double electrical insulation circuit (class II) and therefore does not require an earth connection;
•
Always make observe the minimum distances from walls, furniture and/or objects, as indicated in picture 2.
•
Never install the product on a surface made from wood or synthetic material.
•
This product is water resistant to IP24. It may therefore be used in bathrooms or other areas subject to humidity provided
it is never installed within the perimeter of bathtubs or showers (Volume 1 of figure 3).
•
Do not install the radiator in a draft that could disturb its regulation.
4. Installation
•
Remove the wall-mounting bracket fixed to the back of the radiator, by releasing first the 2 upper springs and then the 2
lower springs as shown in figure 4.
•
Rest the bracket on the floor to use it as a template to mark the points a which the two lower fixing holes are to be made
(figure 5-1).
•
Lift the bracket until its lower fixing points coincide with the marks made on the wall before and use a pencil to mark the
position of the two upper fixing points (figure 5-2).
•
Drill the 4 holes at the points marked previously, and insert the plastic anchors (figure 6).
•
Fix the bracket to the wall using the 4 screws supplied (figure 7).
•
Hook the radiator to the bracket starting with the 2 lower fixing points, and then click the 2 upper fixing points into position
(figure 8).
•
Should you have to remove the radiator from the bracket at a later stage, we recommend releasing the lower two fixing
points first and then the upper fixings.
21
Advertenties
Inhoudsopgave
