Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Attention!
Use the lock button only when using a stand. In
the case of any stopping of the machine or current
interruption the lock button has to be released
immediately by pressing the on/off switch, to
prevent an unintentional restarting of the machine
(danger of injuries)
The mixing machine is equipped with an electronic switch.
With this switch the speed can be regulated according to the pressure on the
button. The use is only recommended for the starting and running out of the
machine to avoid particles flying around.
reduced speed will lead to an overload, as less cooling air will then be
available for the motor and therefore this will be overheated much faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only be appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist. Due to its design, the machine needs a minimum of care and
maintenance. However, the following points always have to be observed:
ƒ
Always keep the power tool and the ventilation slots clean.
ƒ
During work, please pay attention that no particles get inside the
machine.
ƒ
In case of failure, a repair has to be carried out by an authorised
service workshop.
Environmental Protection
Raw Material Recycling instead of Waste Disposal
In order to avoid damages on transportation, the tool has to be delivered in
solid packaging. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
The tool's plastics components are marked according to their material, which
makes it possible to remove environmental friendly and differentiated
because of available collection facilities.
A permanent operating with
13
Advertenties
Inhoudsopgave
